Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IC Controlled Emergency Light with Charger
Post: #1


The circuit shown here is that of the IC controlled emergency light. Its main features are: automatic switching-on of the light on mains failure and battery charger with overcharge protection. When mains is absent, relay RL2 is in deenergised state, feeding battery supply to inverter section via its N/ C contacts and switch S1. The inverter section comprises IC2 (NE555) which is used in stable mode to produce sharp pulses at the rate of 50 Hz for driving the MOSFETs. The output of IC3 is fed to gate of MOSFET (T4) directly while it is applied to MOSFET (T3) gate after inversion by transistor T2. Thus the power amplifier built around MOSFETs T3 and T4 functions in push-pull mode. The output across secondary of transformer X2 can easily drive a 230-volt, 20-watt fluorescent tube. In case light is not required to be on during mains failure, simply flip switch S1 to off position. Battery overcharge preventer circuit is built around IC1 (LM308). Its non inverting pin is held at a reference voltage of approximately 6.9 volts which is obtained using diode D5 (1N4148) and 6.2-volt zener D6. The inverting pin of IC1 is connected to the positive terminal of battery. Thus when mains supply is present, IC1 comparator output is high, unless battery voltage exceeds 6.9 volts. So transistor T1 is normally forward biased, which energises relay RL1. In this state the battery remains on charge via N/O contacts of relay RL1 and current limiting resistor R2. When battery voltage exceeds 6.9 volts (overcharged condition), IC1 output goes low and relay RL1 gets deenergised, and thus stops further charging of battery. MOSFETs T3 and T4 may be mounted on suitable heat sinks.

read more

Important Note..!

If you are not satisfied with above reply ,..Please


So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: emergency light philips circuit, conclusion of automayi emergency light circuit, emergency light diagram, psdel controlled mobile charger project, project using scr as emergency light, emergency light mini project, mini project on emergency light charger*,

Quick Reply
Type your reply to this message here.

Image Verification
Image Verification
(case insensitive)
Please enter the text within the image on the left in to the text box below. This process is used to prevent automated posts.

Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  AUTOMATIC STREET LIGHT CONTROL-EMBEDDED BASED PROJECT project topics 18 13,945 11-02-2016 02:03 PM
Last Post: seminar report asees
  Wireless based Automatic dam water level control shutter open /closed with emergency smart paper boy 4 3,709 11-09-2015 02:00 PM
Last Post: seminar report asees
  COIN BASED MOBILE CHARGER full report seminar class 25 19,140 08-12-2014 11:40 PM
Last Post: seminar report asees
  Automatic Room light Controller with Visitor Counter project topics 26 14,438 12-03-2014 07:22 PM
Last Post: computer topic
  Automatic Street Light Control System seminar surveyer 7 11,713 25-02-2014 12:18 AM
Last Post: Guest
  AUTOMATIC STREET LIGHT CONTROL USING LDR full report seminar class 18 33,845 04-08-2013 06:21 AM
Last Post: Guest
  Density Based Traffic Light Control System seminar class 7 6,630 03-06-2013 02:16 PM
Last Post: Guest
  Military combat robot wireless controlled. Camera helps keeping an eye on border. seminar class 4 2,673 24-04-2013 10:15 PM
Last Post: Guest
  AUTOMATIC STREET LIGHT OPERATION THROUGH SMS project report helper 4 4,308 13-01-2013 12:52 PM
Last Post: Guest
Last Post: seminar details